Official Online Store

Dig Switch 2+ (2 Channel Only)

$70.00

Dig Switch 2+ for 2 Channel Systems

This Unit Requires NO spare channel For 3Ch systems, see the Dig Switch 2+ for 3 Channel Systems. WE RECOMMEND: Use 3CH Dig Switch if your system allows (faster operation)

The Punk RC's Patent Pending Dig Switch is currently THESE ARE SHIPPING WITHIN 10-14 DAYS (updated 08-14-13).

The PunkRC Dig Switch is the easiest and more reliable way to add Dig to your MOA (Motors on Axles) truck.

The NEW Dig Switch 2+.
The new 2+ version is much like the original, but more reliable and powerful.
Higher current connectors to prevent burning out the circuit board if you arc a motor.
Run one motor shorting and the other freewheeling.
More Robust circuit design prevents higher receiver signals from burning out the unit.

The Dig Switch adds Dig Steering to Any Dual Motor Truck. When the Dig is turned on, it will cut power to the appropriate motor. When power is cut to a motor, the motor is SHORTED. This helps the motor lock into place. If you want a motor to freewheel instead of lock, desolder either bead of solder, marked with a "^" above the work "Dig" or "Switch" for Motor1 or Motor2 respectively

The Punk RC Dig Switch also features Surge Absorbers to protect burning of switch terminals. This problem leads to shortened life in many Servo Actuated "Dig-a-ma-jig" Dig Switches.

TX Position | LED | Function
Left | Red | Motor #1 Off
Center | Green | Both Motors On
Right | Blue | Motor #2 Off

Technical Specs:
Size: 1.9"L x 1.0"W x 0.9"H
Power Source: Radio RX
Power Draw: 30-100mA (similar to mini servo)
RX Voltage: 4.8V - 6.5V Receivers
Motor Capacity: Any
Contact Protection: Arc Supressors
Switch Rating: 12Amps @ 35V (each motor)
Water Resistant Electronics (can run underwater)

Hookup:

1 - Plug the Port A wire into your steering channel on the RX (CH1) and Port B wire into your ESC channel on the RX (CH2).
2 - Plug your servo into the Port A jack and your ESC servo wire into the Port B jack.
3 - Solder both Wires from the ESC into the Center Pair of Contacts labeled ESC
4 - Solder both Wires going to Motor #1 (usually Front) to the Outside Contacts labeled Motor #1. Motor #1 may freewheel by de-soldering tab above "DIG" on 2+ Units
5 - Solder both Wires going to Motor #2 (usually Rear) to the Outside Contacts labeled Motor #2
6 - Have TX powered and in neutral when powering the DIg Switch. It will auto-read your center steering and neutral positions. If you trim your steering or throttle, you may need to restart you Dig Switch

Dig Switch 2CH Hookup Video.
This Video is how to hookup a 2ch Dig Switch into your system.
http://www.youtube.com/watch?v=F18LqBrNjxc

RC Crawler Giveaway Code:
First two letters of your First Name and Two numbers from your House Address and scramble them.
Example. Joe on 56 Street Dr= J65O


Add to Cart:

  • Model: DigSwitch-2CH
  • 13 Units in Stock


This product was added to our catalog on Friday 19 March, 2010.

Your IP Address is: 54.145.122.109
Copyright © 2017 Punk RC. Powered by Zen Cart